|
Caratteristiche principali
Introducing the Ultra-Compact DI-Boxes from BEHRINGER
There are times when you will want to connect certain sound
sources straight to other audio gear, be it for a live
performance or a studio session. A direct connection between
audio equipment can be a challenge though: technical problems
crop up that'll corrupt the signal.
The DI400P lets you connect instruments or amplifier outputs.
It converts any unbalanced signal to a balanced signal and
eliminates unwanted noise. With its high-performance
transformer, it also allows you to use very long cables without
the loss of high frequencies.
This is the sort of medicine that'll cure headaches in your
studio or on stage.
Input Section
|
Input Impedance |
1M Ohm (pad at 0dB) |
|
|
47k Ohm (pad at -20dB) |
|
|
47k Ohm (pad at -40dB) |
|
|
|
|
Max Input Level |
+9dBu (pad at 0dB) |
|
|
+29dBu (pad at -20dB) |
|
|
+49dBu (pad at -40dB) |
|
|
|
|
Connectors |
Two Parallel 1/4" jack connectors and a parallel XLR
connector (unbalanced) |
|
|
|
|
Jack: |
Tip Hot (+ve) |
|
|
Sleeve Ground |
|
|
|
|
XLR: |
Pin 2 Hot (+ve) |
|
|
Pin 1 & 3 Ground |
Output Section
|
Output |
Transformer Balanced |
|
|
|
|
Max. Output Level |
+8dBu into 600 Ohms or greater |
|
|
|
|
Connector |
XLR3-32 or equivalent |
System Performance
|
Distortion (THD) |
< 0.005% at 1khz, 0dbu output |
|
|
|
|
Noise |
< -105db unweighted, 22hz-22khz, rms* |
|
|
|
|
Frequency Response |
30Hz to 20kHz, +0dB/-1dB |
General
|
Main/Standby battery |
9 volt PP3 type, preferably alkaline. |
|
|
|
|
Current drain |
on phantom - less than 7.5mA |
|
|
on battery - less than 2mA. |
|
|
|
|
Phantom Power |
+20 volts DC to +48 volts DC |
|
|
|
|
Weight |
650 gms, excluding batteries. |
|
|
|
|
Overall Dimensions |
59 mm x 124 mm x 143 mm (2.3" x 4.9" x 5.6") |
|
